Origin and mechanisms of dust emission from pulse-jet cleaning filter media

  • Autor:

    J. Binnig, J. Meyer, G. Kasper

  • Quelle:

    Powder Technology, 2009, 189/1, 108-114

  • The respective contributions of direct particle penetration vs. particle reentrainment to emissions of pulse-jet cleaned filter media were measured for needle felts of different construction, in combination with two particle materials, one free-flowing and one agglomerating. Different media conditioning protocols (including accelerated aging up to 20,000 pulses) were applied as well, in order to simulate longer-term use of the filters.

    With about 96–99% of emissions per cycle, direct particle penetration was by far the dominant mechanism under all circumstances. The size distribution of emitted particles was centred narrowly around the MPPS between 0.5 and 1 µm, and tended to shift toward finer particles with progressive media aging, much like in a depth filter. The total reentrained dust mass per cycle was on the order of 10− 5 of the mass stored inside the medium. Cross-sectional analysis of a few media by electron microprobe indicates that the support scrim may act as an effective barrier to particle seepage more than to direct penetration.

    The well known increase in emission level with cleaning pulse intensity can be attributed to a slowing-down or prevention of the clogging process, rather than enhanced reentrainment of stored dust. Earlier reports of increased emissions at higher filter face velocities are probably due to the redeposition of dust from the filter cake immediately after a cleaning pulse.